Setup:RPI

From SingletonMillerWiki
Revision as of 14:33, 3 June 2012 by Martin (Talk | contribs)

Jump to: navigation, search


Resources

http://www.raspberrypi.org/downloads, get your first imager file here.

http://elinux.org/RPi_Beginners

http://elinux.org/RPi_Easy_SD_Card_Setup#Copying_the_image_to_an_SD_Card_on_Windows, follow these notes for burning your image to an SD card.

First Boot

Flash your RPi with a vanilla build of debian using the above resources as a direct guide.

Connect to your TV, net and apply power. In order for the HDMI to detect my TV I needed to have the TV set to the correct channel before powering up the RPi.

Let the debian first boot setup run through, the on screen notes stated that the code may hang. I found that just leaving the process to run it will complete after about 5 minutes.

Login

Login for the first time.


<code> username: pi </code>

<code> password: raspberry </code>

Change Default Password

It important to change the default user password in order to procect your RPi security when connected to the Internet.

Enter the following command to change pi's password.

passwd

The follow the instructions, note the programme will discourage the use of weak passswords, consider adding at least one capital leter and one number.

Reboot the RPi by cycling the power or using the code:

sudo shutdown -r now

When asked enter your new password.

sudo, is command that enables a user to assume super user privledges.

shutdown -r now, codes the shutdown command to restart at the time now.