Difference between revisions of "HDMI Configuration"

From SingletonMillerWiki
Jump to: navigation, search
Line 30: Line 30:
 
</pre>
 
</pre>
  
This put the image at full 1920 x 1080. This put the image right to the edges, but was a too close. Edited the config.txt to read.
+
This put the image at full 1920 x 1080. This also put the image right to the edges; this is too close. Edited the config.txt to read.
  
 
<pre>
 
<pre>

Revision as of 12:10, 13 June 2012


http://www.69b.org/prox-pi.php/rpo/phpBB3/viewtopic.php?f=5&t=5851

http://elinux.org/R-Pi_ConfigurationFile

http://elinux.org/RPi_config.txt

http://www.raspberrypi.org/phpBB3/viewtopic.php?f=28&t=7693


Example Problem: 1920 x 1080 @ 60Hz Monitor Image format provided by RasPi, as above. Reported by monitor and by RasPi.

tvservice -s

Reduced image size.

lxde -> Preferences -> Monitor reports 1824 x 984

Solution (Information obtained from above references): Generated a /boot/config.txt file added line

disable_overscan=1

This put the image at full 1920 x 1080. This also put the image right to the edges; this is too close. Edited the config.txt to read.

disable_overscan=1
overscan_left=5
overscan_right=5
overscan_top=5
overscan_bottom=5

This gave the image a 5 pixel border.

Occasionally the RasPi reboots with a centralised colour reference square, but generally boots normally.

References above also give information as to disable the RasPi HDMI Hot-Plug Detection which will enable the HDMI output even if no Monitor is detected.