Difference between revisions of "HDMI Configuration"
| Line 44: | Line 44: | ||
Occasionally the RasPi reboots with a centralised colour reference square, but generally boots normally. | Occasionally the RasPi reboots with a centralised colour reference square, but generally boots normally. | ||
| − | References above also give information as to disable the RasPi HDMI Hot-Plug Detection which will | + | References above also give information as to disable the RasPi HDMI Hot-Plug Detection which will enable the HDMI output even if no Monitor is detected. |
Revision as of 12:08, 13 June 2012
http://www.69b.org/prox-pi.php/rpo/phpBB3/viewtopic.php?f=5&t=5851
http://elinux.org/R-Pi_ConfigurationFile
http://elinux.org/RPi_config.txt
http://www.raspberrypi.org/phpBB3/viewtopic.php?f=28&t=7693
Example Problem:
1920 x 1080 @ 60Hz Monitor
Image format provided by RasPi, as above. Reported by monitor and by RasPi.
tvservice -s
Reduced image size.
lxde -> Preferences -> Monitor reports 1824 x 984
Solution (Information obtained from above references): Generated a /boot/config.txt file added line
disable_overscan=1
This put the image at full 1920 x 1080. This put the image right to the edges, but was a too close. Edited the config.txt to read.
disable_overscan=1 overscan_left=5 overscan_right=5 overscan_top=5 overscan_bottom=5
This gave the image a 5 pixel border.
Occasionally the RasPi reboots with a centralised colour reference square, but generally boots normally.
References above also give information as to disable the RasPi HDMI Hot-Plug Detection which will enable the HDMI output even if no Monitor is detected.
